To rip off the tongue and groove edges set the table saw to the width of the tongue groove and run the board through the saw.
Tongue and groove flooring table top.
The great thing about tongue and groove.
Here are the steps we took to build the hardwood floor table top.
Stand up or grab a stool.
Features a sandblasted natural hand applied finish.
Make sure the frame is the correct height so that the flooring boards will be flush to the top edge of the frame.
Expertly crafted of kiln dried solid spruce and veneers with tongue and groove joinery.
Turn the board around and make another pass.
Top is adjustable and can tilt.
You can sand it all out once assembled and then attach your edging which you should be able to rip from some of the flooring pieces.
Feb 1 2014 a table i made from leftover tongue and groove flooring.
If the flooring has the grooves in the underside you may want to nail through the tongue as though you were applying it as flooring.
Select the good side of each one.
The new top is old tongue and groove pine attic flooring from the early 20 s.
Step 2 assemble the wood pieces and make sure they all fit into each other.
The tilt top francisco drafting desk inspired by a drafting table is ideal for creative endeavors.
Select enough hardwood flooring boards so that the accumulated width of them together exceed the width and length of the desired table top by at least 2 inches.
I made a frame of the same wood and it anchors the piece.
Tongue and groove joints are commonly made on a table saw the best method in cutting tongue and groove joints for floor panels is through the shaper.
How to make a reclaimed tongue groove table top step 1 find or buy some tongue groove lumber.
Set the fence on the router table so that the bit will cut approximately through the center of the board.
My hubby carpenter cut the pieces of flooring to length.
This project started with a visit the wooden duck in berkeley ca just.
If there is no groove you should be able to glue it directly to the plywood.
The same bit can be used to cut both pieces of the joint cut the groove first.